Best way to prevent damage and improve rotation
When a bale stays trapped in the chamber instead of being ejected, it can harm new bales at the beginning of the season by causing damage to the net via the rollers. Also, rusty or paint-covered surfaces on the new sides can prevent the bale from rotating smoothly for the initial few bales. We recommend disengaging the PTO (Power Take-Off) before ejecting the bale until the side walls have been polished or smoothened. That way you can roll on smoothly into a trouble-free season!
Dealing with twine snags
When you’re linking the spools in a twine box, it takes a lot of time. So, it’s better to do it correctly to prevent issues! Connecting the spools creates a flatter knot that can smoothly go through the twine guides and tensioners.
Uneven twine at the start of a spool
Sometimes, the first 10-20 meters of twine from a spool may look uneven and kinked. This is normal and happens because of how the twine is made and wound onto the spool before packaging. When you pull the twine tight, it straightens out. As the twine moves towards the knotting part, it goes through tensioning with spring clamps in the twine box and twine brakes just before the knotter. These brakes need to be set at a specific tension. When done right, the twisted twine won’t cause any issues!
Twine looks like a bird's nest
Take care with your spools before use, they are fragile. In order for the twine to run smoothly from the start to the very end, the spools must not be damaged or ‘shocked’ (dropped or crushed), as this will disrupt the careful winding pattern inside and cause the spool to fall apart internally.
Twine is twisted into a knot
When pulling twine from the spool, make sure to pull it from only one end-the right end! You can tell it’s the right end if it unwinds in a counter-clockwise direction from the inside surface. If you pull from the wrong end, you’ll end up with a big knot in the twine, causing problems in the knotter very quickly!
